SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, radiation cross-linked modified polyvinylidene fluoride. Color: natural. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Cd18 per ANSI J-STD-006. FLUX: TYPE ROL1 per ANSI J-STD-004. 3. MELTABLE RING: Thermally stabilized thermoplastic. Color: blue. 4. MELTABLE RING: Thermally stabilized thermoplastic. Color: gray. APPLICATION 1. This part is designed to provide an environment protected shield termination on cables, rated for at least 105C minimum, and having tin or silver plated shields. 2. Part may be used on cables having a maximum diameter of 6.48 (0.255) and a minimum diameter of 3.18 (0.125) when measured as shown below. 3. This part is designed to meet the requirements of Raychem Specification RT-1404. 4. Install using Raychem-approved convection or infrared heating tools in accordance with Raychem Process Standard RCPS-100-70. For best results, prepare the cable as shown: 307 Constitution Drive Menlo Park, CA 94025, USA Wire and Harnessing Products TITLE: 6.48 (0.255) I.D. SOLDERSLEEVE, LOW TEMPERATURE Unless otherwise specified dimensions are in millimeters. Inches dimensions are in between brackets. Tyco Electronics reserves the right to amend ANGLES: N/A TOLERANCES: this drawing at any time. Users should 0.00 N/A evaluate the suitability of the product for their ROUGHNESS IN 0.0 N/A application. MICRON 0 N/A DRAWN BY: DATE: PROD. REV. M. FORONDA 11-Apr.-01 B If this document is printed it becomes uncontrolled. Check for the latest revision. DOCUMENT NO.: D-142-56 DCR NUMBER: REPLACES: D010115 DOC ISSUE: 1 SCALE: None N/A SIZE: A SHEET: 1 of 1