TC05 Series Thin Film Resistors
Page <1> 02/05/08 V1.1
Specification Table
Ambient temperature (°C)
Power Rating:
Resistors shall have a power rating based on continuous load operation at an ambient temperature of 70°C. For temperature in
excess of 70°C, The load shall be derate.
Derating Curve
Type Power Rating
(W)
Maximum
Working
Voltage
(V)
Maximum
Overload
Voltage
(V)
Temperature
Range
(°C)
Ambient
Temperature
(°C)
Resistors Range
(Special Low)
(ΩΩ)
Resistors
Range
(ΩΩ)
Resistors
Range
(Special High)
(ΩΩ)
RMC TC05 0.10 (1/10) 100 200 -55 to +155 70 4.7 to 9.76 10 to 1M 1.1M to 2M
Nominal Resistance
Effective figures of nominal resistance shall be in accordance with E-24, E-96 and E-192 series. E-96 for 1%, E-24 series for 2%, 5%,
10% and E-192 for 0.5%, 0.25%, 0.1% .
TC05 Series Thin Film Resistors
Page <2> 02/05/08 V1.1
Construction:
Power Rating and Dimensions
Dimensions
Dimensions : Millimetres
Type L ±0.15 W + 0.15
- 0.10 T ±0.10 D1 ±0.20 D2 ±0.25
TC05 2.00 1.25 0.55 0.40 0.40
Power Rating
Type
Power Rating
at 70°C
(W)
Tolerance
%
Resistance
Range
(Special Low)
(ΩΩ)
Resistance
Range
(ΩΩ)
Resistance
Range
(Special High)
(MΩΩ)
Standard
Series PPM/°C
TC05 0.10 (1/10) ±0.1 4.7 to 9.76 10 to 1M 1.1 to 2 E-192 25
Dimensions : Millimetres
TC05 Series Thin Film Resistors
Page <3> 02/05/08 V1.1
Characteristics Limits Test Methods (JIS C 5201-1)
Temperature coefficient 4.7Ωto 2MΩ±25 PPM/°C
Natural resistance change per temperature degree
centigrade
R2-R1/ R1(t2-t1) x 106(PPM/°C)
R1: Resistance value at room temperature (t1)
R2: Resistance value at room temperature plus
100°C (t2).
Short time overload Resistance change rate is ±(0.5% + 0.05Ω)Permanent resistance change after the application of a
potential of 2.5 times RCWV for 5 seconds.
Insulation resistance >1,000MΩApply 100V DC between protective coating and
termination for 1 minimum, then measure
Dielectric withstanding
voltage
No evidence of flashover mechanical
damage, arcing or insulation break down. Apply maximum. overload voltage for 1 minute.
Terminal bending ±(0.2% + 0.05Ω)Twist of test board : Y/X = 5/90mm for 10
seconds.
Soldering heat Resistance change rate is ±(0.2% + 0.05Ω)
Dip the resistor into a solder bath having a
temperature of 260°C ±5°C and hold it for 10 ±1
seconds
Load life in humidity Resistance change rate is ±(0.3% + 0.05Ω)
Resistance change after 1000 hours
(1.5 hours "on", 0.5 hour "off" ) at RCWV
in a humidity chamber controlled at
40°C ±2°C and 90 to 95% relative humidity
Load Life
Resistance change rate is
±(0.2% + 0.05Ω)
>7KΩ±(0.5% + 0.05Ω)
Permanent resistance change after 1000 hours
operating at RCWV, with duty cycle of
(1.5 hours"on", 0.5 hour"off") at 70°C ±2°C ambient.
Solderability 95% coverage minimum Test temperature of solder : 260°C ±5°C
Dipping them solder : 2 ±0.5 seconds.
Marking on the Resistors:
±0.1% Tolerance : 4 Digits, the first three digits are singnificant figures of resistance and the fourth digit denoted number of
zeros.Letter"R" is for decimal point.
1000 100Ω2741 2.74KΩ
Performance specifications
TC05 Series Thin Film Resistors
Page <4> 02/05/08 V1.1
Resistance Preferred Value Range
E6 E12 E24 E96 E6 E12 E24 E96 E6 E12 E24 E96
10 10 10 10.0
10.2
10.5
10.7
11 11.0
11.3
11.5
11.8
12 12 12.1
12.4
12.7
13 13.0
13.3
13.7
14.0
14.3
14.7
15 15 15 15.0
15.4
15.8
16 16.2
16.5
16.9
17.4
17.8
18 18 18.2
18.7
19.1
19.6
20 20.0
20.5
21.0
21.5
22 22 22 22.1
22.6
23.2
23.7
24 24.3
24.9
25.5
26.1
27.7
27 27 27.4
28.0
28.7
29.4
30 30.1
30.9
31.6
32.4
33 33 33 33.2
34.0
34.8
35.7
36 36.5
37.4
38.3
39 39 39.2
40.2
41.2
42.2
43 43.2
44.2
45.3
46.4
47 47 47 47.5
48.7
49.9
51 51.1
52.3
53.6
54.9
56 56 56.2
57.6
59.0
60.4
62 61.9
63.4
64.9
66.5
68 68 68 68.1
69.8
71.5
73.2
75 75.0
76.8
78.7
80.6
82 82 82.5
84.5
86.6
88.7
91 90.9
93.1
95.3
97.6
Above values in accordance with IEC Publication 63 (1963) and BS2488
TC05 Series Thin Film Resistors
Page <5> 02/05/08 V1.1
Part Number Explanation:
TC05
Product
Type
MC 1000
Ohmic Value
T
Packing
Type
5
Packing
Quantity
E
Special
Feature
25
Temperature
B
Tolerance
Product Type : TC05 = 0805.
Temperature : 25 = 25PPM.
Tolerance : B = ±0.1%.
Ohmic Value : Where R = Ohms = Ω.
K = Kiloohms = KΩ.
M = Megaohms = MΩ.
And replaces the decimal point.
eg: 1R5 = 1.5Ω.
4K7 = 4.7KΩ.
6M8 = 6.8MΩ.
Parking Type : T = T/R Packing.
Packing Quantity : 5 = 5000 pieces.
Special Feature : E = Lead free plating type.
Stocked Values
Tolerance Wattage (W) Preferred Value Range Range Value
1% 0.063 E96 1R5 - 1M
1% 0.1 E24 1R5 - 1M
1% 0.125 E24 10R - 1M
For enquiries from all other markets
TC05 Series Thin Film Resistors
Page <6> 02/05/08 V1.1
Notes:
International Sales Offices:
AUSTRALIA – Farnell
Tel No: ++61 1300 361 005
Fax No: ++61 1300 361 225
FRANCE – Farnell
Tel No: ++ 33 474 68 99 99
Fax No: ++ 33 474 68 99 90
NORWAY – Farnell
Tel No: 800 146 70
Fax No: 800 146 76
AUSTRIA – Farnell
Tel No: ++ 43 662 2180 680
Fax No: ++ 43 662 2180 670
GERMANY – Farnell
Tel No: ++ 49 89 61 39 39 39
Fax No: ++ 49 89 613 59 01
PORTUGAL – Farnell
Tel No: ++ 34 93 475 8804
Fax No: ++ 34 93 474 5288
RUSSIA – Farnell
Tel No: ++ 44 870 1200 208
Fax No: ++ 44 870 1200 209
ESTONIA – Farnell
Tel No: ++ 358 9 560 7780
Fax No: ++ 358 9 345 5411
NETHERLANDS
– Farnell
Tel No: ++ 31 30 241 7373
Fax No: ++ 31 30 241 7333
UK – Farnell
Tel No: ++ 44 8701 200 200
Fax No: ++ 44 8701 200 201
SINGAPORE
–
Farnell-Newark
Tel No: ++ 65 6788 0200
Fax No: ++ 65 6788 0300
HONG KONG
–
Farnell-Newark
Tel No: ++ 852 2268 9888
Fax No: ++ 852 2268 9899
HUNGARY
- Farnell
Tel No: ++ 44 870 1200 208
Fax No: ++ 44 870 1200 209
BELGIUM – Farnell
Tel No: ++ 32 3 475 2810
Fax No: ++ 32 3 227 3648
BRAZIL – Farnell-Newark
Tel No: ++ 55 11 4066 9400
Fax No: ++ 55 11 4066 9410
IRELAND – Farnell
Tel No: ++ 353 1 830 9277
Fax No: ++ 353 1 830 9016
INDIA
- Farnell
Tel No: ++ 44 870 1200 208
Fax No: ++ 44 870 1200 209
ISRAEL – Farnell
Tel No: ++ 180 937 0015
Fax No: ++ 180 937 0014
SPAIN – Farnell
Tel No: 901 20 20 80
Fax No: 901 20 20 90
CHINA – Farnell-Newark
Tel No: ++86 10 6238 5152
Fax No: ++86 10 6238 5022
CZECH REPUBLIC
- Farnell
Tel No: ++ 44 870 1200 208
Fax No: ++ 44 870 1200 209
ITALY – Farnell
Tel No: ++ 39 02 93 995 200
Fax No: ++ 39 02 93 995 300
SWEDEN – Farnell
Tel No: ++ 46 8 730 50 00
Fax No: ++ 46 8 83 52 62
MALAYSIA –
Farnell-Newark
Tel No: ++ 60 3 7873 8000
Fax No: ++ 60 3 7873 7000
SWITZERLAND
– Farnell
Tel No: ++ 44 204 64 64
Fax No: ++ 44 204 64 54
DENMARK – Farnell
Tel No: ++ 45 44 53 66 44
Fax No: ++ 45 44 53 66 06
UK –CPC
++ 44 8701 202 530
++ 44 8701 202 531
USA –
Newark
Tel No: 800 463 9275
NEW ZEALAND
– Farnell
Tel No: 0800 90 80 80
Fax No: 0800 90 80 81
EXPORT – Farnell
Tel No: ++ 44 8701 200 208
Fax No: ++ 44 8701 200 209
export
FINLAND – Farnell
Tel No: ++ 358 9 560 7780
Fax No: ++ 358 9 345 5411
Disclaimer This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes
in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied.
The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data
sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage
resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded.
This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. SPC Multicomp is the registered trademark of the Group. © Premier Farnell plc 2008.
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk
