Page 1
Autec Power Systems
667 E Cochran St, Simi Valley, CA93065
Tel: (805)522-0888
Fax: (805)522-8777
www.autec.com
10 December 2014
Model
SP-500-15
SP-500-24
SP-500-48
Output Requirements
Voltage (1)
15V
24V
48V
Rated Current
33.5A
21A
10.5A
Current Range
(Convection)
0 ~ 26.7A
0 ~ 16.7A
0 ~ 8.4A
Rated Power (10.5CFM
Fan)
0 ~ 33.5A
0 ~ 21A
0 ~ 10.5A
Rated Power
(Convection)
400.5W
400.8W
403.2W
Rated Power (10.5 CFM
Fan)
502.5W
504W
504W
Ripple & Noise (Max)
(2)
150 mVp-p
150 mVp-p
150 mVp-p
Voltage Adjustment
Range
13.5 ~ 16.5V
21.6 ~ 26.4V
43.2 ~ 52.8V
Voltage Tolerance (3)
± 2%
± 2%
± 2%
Line Regulation
± 1%
± 1%
± 1%
Load Regulation
± 2%
± 2%
± 2%
Setup, Rise Time
600ms, 30ms at full load
Hold Time
16ms / 230VAC at full load
Input
Requirements
Voltage (4)
90V ~ 264VAC / 127 ~ 370VDC
Frequency
47Hz ~ 63Hz
Efficiency (Typ.)
90%
90%
90%
91%
AC Current (max.)
6 A / 115VAC 2A / 230VAC
Inrush Current (Typ.)
30A / 115VAC 44A / 230VAC
Leakage Current
< 2mA / 230VAC
Protection
Requirement
Over Load
> 105% rated output power Protection type: constant current limiting, output voltage less than 50%
rating DC voltage range after 500ms the unit will shutdown
Over Voltage
115% ~ 150% rated output voltage Protection type: latch-off mode
Over Temperature
95°C With N2 sense by T1 core ±5°C, 95°C With TH1 sense near D26 heat sink ±5°C
Environmental
Conditions
Operating Temperature
-20°C ~ +65°C (Refer to output load de-rating curve)
Operating Humidity
20 ~ 90% RH non-condensing
Storage Temperature,
Humidity
- 40 +85℃ / 10 ~ 95% R.H~
Temperature Coefficient
±0.03%/℃ (0 ~ 50℃)
Vibration
10 ~ 500HZ, 2G 10min./ 1 cycle, period for 60 min. Each along X,Y,Z axes
500W Single Output with PFC Function SP-500 series
Universal AC Input / Active PFC
A DC fan is provided
Protections: Short-Circuiting / Over-load / Over-
voltage / Over-temperature
Cooling-Free Air Convection for 400w and 500W with
23.5CFM forced
All Using 105°C Long-Life Electrolytic Capacitors
2 Mode – Remoter for ON/OFF Ctrl. Which is Setup by User
High Operating temperatures of up to 65°C
Remote Voltage Sense
Power “OK” Signal
High Power Density 6.4w/in^3
U-Bracket Low Profile: 38mm
Withstands 2G Vibration Testing
Active AC Surge Current Limiting
High Efficiency, Long Life, and High Reliability
3 Year Warranty
SPECIFICATION
FEATURES
Page 2
Autec Power Systems
667 E Cochran St, Simi Valley, CA93065
Tel: (805)522-0888
Fax: (805)522-8777
www.autec.com
10 December 2014
Safety & EMC (5)
Safety Standards
UL 60950-1, 2nd Edition, TUV EN60950-1 : 2006+A11 Approved
Withstand Voltage
I/P -O/P : 4242 DC I/P -FG : 2121 DC 1 minute
Isolation
Resistance
I/P -O/P,I/P -FG, O/P -FG:100M Ω /500VDC
EMI Conduction &
Radiation
EN55022: 2006 Class B
Harmonic Current
EN61000-3-2: 2006 Class A, EN61000-3-3: 1995+A1: 2001+A2: 2005
EMS Immunity
EN61204-3: 2000, EN55024: 1998+A1: 2001+A2: 2003 light industry level, criteria A
Others
Connection
I/P 3P / 9.5mm terminal block with cover, O/P : 8P/9.5mm terminal block with cover
Power Ok signal
Open Darin. Max 30Vdc / 0.1A
Cooling
Free Air convection for 400W, With23.5CFM Fan for 500W
MTBF (MIL-
HDBK-217F)
ON/OFF Remote
Control
Two modes setup remote ON/OFF see Function Description of J2
Remote Voltage
Sense
Compensates for wire voltage drop
Dimension
(W*H*D)
254 x 127 x 38(mm) or 10 x 5 x 1.50(inches)
Packing
1.7kg : 12Pcs / 20.4KG
Model
SP-500-12
SP-500-15
SP-500-24
SP-500-48
NOTES:
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature. 2. Ripple &
noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47 uf parallel capacitor.
3. Tolerance: includes set up tolerance, line regulation and load regulation.
4. De-rating may be needed under low input voltages. Please check the de-rating curve for more details.
5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-
confirmed that it still meets EMC directives.
6. In parallel connection, maybe only one unit operate if the total output load is less than 5% of rated load condition.
Page 3
Autec Power Systems
667 E Cochran St, Simi Valley, CA93065
Tel: (805)522-0888
Fax: (805)522-8777
www.autec.com
10 December 2014
Page 4
Autec Power Systems
667 E Cochran St, Simi Valley, CA93065
Tel: (805)522-0888
Fax: (805)522-8777
www.autec.com
10 December 2014
Page 5
Autec Power Systems
667 E Cochran St, Simi Valley, CA93065
Tel: (805)522-0888
Fax: (805)522-8777
www.autec.com
10 December 2014
SP-500-24
Switching Power
(Opern Frame)
Watts
Voltage