refer to the list of supported devices.

Note:

Once the installation has taken place the E10A USB will support devices in that group only, unless a Device Group Additions is

purchased. To add further device groups, the user can purchase Device Group Additions software (License Tool for Device

Group Additions) for the required Group.

If a new device which is included in the device group you installed to your E10A-USB is released, downloading the latest

emulator software will add the new device to your E10A-USB.

Periodically new devices will be added to device groups, if an E10A-USB is programmed to support SH-3 for instance and a

new SH-3 device is added to the list of devices supported by E10A-USB, Renesas will make available a patch to update the

E10A-USB free of charge.

Note:

You do not need to purchase a Device Group Addition (License Tool for Device Group Additions) to support the first device

group, the E10A-USB is shipped with an installer that allows the user to support any one of them. Our range of Device Group

Additions is for adding subsequent device groups to an existing system.

Device Group Additions are prepared for each device group. It can be purchased from your Renesas supplier or distributor by

ordering the appropriate part number from the table below and are delivered in on CD-ROM.

One license is available for one E10A-USB.

If a user has purchased a Device Group Addition or selected a Device Group at initial installation then there is no need to

purchase a new Device Group Addition to add new devices within the same Device group even if they are released at a later

date. As for supported devices in each group, visit "Target Devices" .

New_SH-Mobile HS7318KCU01SR New_SH-Mobile device group addition

Back to Top

1. Open the sliding switch cover and check that the switch ( SW1 ) for setting the emulator is turned to "1".

The Emulator Software for

the E10A-USB Emulator

(HS0005KCU01H /

HS0005KCU02H)

Latest Ver.: V.3.06 Release 00

Released: June 16, 2013

Details of upgrade (Tool

News)

News)

Evaluation Software

Tools Download

Tool News

Windows compatibility

status

Online training

Tool Environmental Information

Back To Top

HS0005KCU01H

HS0005KCU14H

E1 (R0E000010KCE00)

E20 (R0E000200KCT00)

MINICUBE2

MINICUBE

External Flash Definition

Editor

E8a

E10T-USB

E30A

2. Select [ Renesas ] -> [ License Tool for E10A-USB ] -> [ SHxxxx ( H8S/xxxx ) Device Group ] from [ Programs ] in the [ Start

1. In case "-----" is shown in (a), no device group is set in E10A-USB.

Do not use "License Tool for Device Group Additions".

2. Use "License Tool for Device Group Additions" only when "-.-.--.---" is shown in (b).

3. If the following error message is displayed, the host computer is not connected to the emulator or the setup switch (

SW1 ) is turned to "0". In case the setup switch ( SW1 ) is turned to "0", set it to "1" and connect the USB cable again.

not a problem.

3. Do NOT turn off the host computer or disconnect the USB cable while setting up the emulator. Or, the

emulator may be damaged.

After completing addition of a device group, set up E10A-USB.

For further information to set up E10A-USB, see here .

Back to Top