CABLE BREAKOUT BOOTS, THREE ENTRY MODIFICATIONS Table of Dimensions, inch (mm): PART NUMBER (SEE NOTE*) EXP. (A), MIN T42-100FR-01 T42-100FR-02 T42-100FR-G02 T42-100FR/ ROUND-BASE Note*: LENGTH RECOVERED MIN LEG ID BODY ID REC'D. (B), MAX EXP. (C), MIN REC'D. (D), MAX REC'D. WALL THICKNESS REF (E), BODY (F), LEG 1.70 (43) 1.70 (43) 1.70 (43) 0.90 (23) 0.90 (23) 0.90 (23) 0.95 (24) 0.95 (24) 0.95 (24) 0.30 (8) 0.30 (8) 0.30 (8) 2.3 (58) 1.2 (30) 1.2 (30) 1.2 (30) 1.2 (30) 1.2 (30) 0.12 (3.0) 0.12 (3.0) 0.12 (3.0) (W) 2.10 (53) 0.90 (23) 0.82 (21) 0.30 (8) 2.3 (58) 1.2 (30) 0.12 (3.0) Add "NA" to the end of Part Number if no adhesive is required Material: Heat shrinkable boot material in accordance with -3 polyolefin Factory applied sealant: Factory applied hot melt adhesive is standard. CUSTOMER DRAWING TITLE: Raychem Molded Parts 305 Constitution Drive, Menlo Park, CA 94025 Unless otherwise specified dimensions are in inches. [Metric dimensions are shown in brackets CABLE BREAKOUT BOOT, THREE ENTRY MODIFICATIONS DOCUMENT NO.: TXXX-XXXFR-XX REV: Tyco Electronics reserves the right to amend this drawing at any time. Users should evaluate the suitability of the product for their application. REVISED BY: CAGE CODE: D SCALE: DATE: None FILE : Org. Date: U. Nguyen 06090 TXXX-XXXFR-XX.doc 5/7/07 (c) 2007-2008 Tyco Electronics Corporation. All rights reserved If this document is printed it becomes uncontrolled. Check for the latest revision. October 6, 2008 SIZE A SHEET: 1 of 1