JNPS-0846
9
6-3 ELECTRICAL SPECIFICATIONS
TEST
DESCRIPTION REQUIREMENT TEST CONDITION
RELATED
STANDARD
DIELECTRIC
WITHSTANDING
VOLTAGE
No appearance of arcing
and break down.
Leak current: 1mA Max.
Impressed voltage is AC 1000V rms.
between adjacent two contacts for one
minute.
――――
INSULATION
RESIDENSE
1000MΩ Min. Impressed voltage is DC 500V between
adjacent two contacts for one minute. ――――
CONTACT
RESISTANCE
- Initial /
25 mΩ Max.
- Change of contact
resistance after
environmental tests /
20 mΩ Max.
Contact resistance is measured
at Short Circuit.
Current: 1.5mA
Open Circuit Voltage: 20mV
by 4 terminal method.
* Measurement values include
the resistance of contact pins
as conductive material.
* Refer to Table 1 regarding the conditions
of each environmental test.
See Table 1.
Table 1: ENVIROMENTAL TEST
ITEM TEST CONDITION RELATED STANDARD
MOISTURE -10 ∼ 65°C, Relative Humidity 95% / 10 cycles MIL-STD-202F106D
SALT SPRAY NaCl 5% solution, 35°C / 48 hours MIL-STD-202F101D
THERMAL SHOCK -55°C→25°C→85°C→25°C / 5 cycles MIL-STD-202F107G
HUMIDITY
(STEADY STATE) 40°C, Relative Humidity 95% / 96 hours MIL-STD-202F103B
THERMAL LIFE Steady Current: Current Rating × 110%, 85°C / 1000 hours ――――
H2S GAS 3 ± 1 ppm, 40°C, Relative Humidity 70 ∼ 80% / 96 hours JEIDA-38-1984
7. PLATING SPEC INDICATION ON CONNECTOR
The first letter, in stamped 3 letters on the connector body for lot numbering, identified the following
plating specs.
N XX or n XX : PR plating
C XX or c XX : SC plating
S XX or s XX : S plating
* XX : two alphabet letters
8. PACKAGE & IDENTIFICATION
These products are packed with plastic tray and carton box for transit.
Carton box are identified by part number, quantity, maker name and lot number.